Loading ...
Loading ...
Loading ...
BELT INSTALLATION
• Place V part of belt intogrooves On
engine pulley and front V-idler, making
sure to route belt inside of all belt keep-
ers.
• Route belt on right side, coming from V-
idler, towards back of tractor, above
midspan belt keeper and to top of
transaxle pulley,
• Route belt on left side, coming from
engine pulley, towards back of tractor
and through loop in midspan belt keep-
er.
• Place V part of belt into grooves on
transaxle and fan idler pulleys, making
sure to route belt inside of all belt keep-
ers.
• Retighten belt keeper above transaxle
pulley.
• Place belt around clutching idlers as
shown, making sure to route belt inside
of all belt keepers.
• Check to be sure belt is positioned cor-
rectly and is on proper side of all belt
keepers.
• Reinstall mower.
IMPORTANT: Check brake adjustment.
Tractor V-Belt Drive Schematic
Viewed from L.H. Side of Tractor
Belt Transaxle
Keeper
Engine
Pulley Clutching
Belt Keepers Bel!
Belt Fan
Keeper Idler
As Viewed fron
- V-Idler
Bottom
TO ADJUST MOTION CONTROL LEVER
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
If for any reason the motion control lever
will not hold its position while at a selected
speed, it may be adjusted at the friction
pack located on the right side of chassis.
• Park tractor on levelsurface. Stop trac-
tor by turning ignition key to "OFF" posi-
tion and engage parking brake.
• Place motion control lever in neutral (N)
position.
• While holding Iocknut, loosen jam nut
.* Tighten Iocknut 1/4 turn.
While holding Iocknut, tighten jam nut
se_hrely.
NOTE: If for any mason the effort to
move the motion control lever becomes
too excessive, reverse the above adjust-
ment procedure by loosening Iocknut 1/4
turn.
Road test tractor after adjustment and
repeat procedure if necessary.
TRANSMISSION REMOVAL/REPLACE-
MENT
Should. your transmission require
removal mr service or replacement, it
should be purged after reinstallation
and before operatin.qthe tractor. See
"PURGE TRANSMISSION" in the
Operation section of this manual.
Locknut
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steeringwheel crossbars are not hori-
zontal (le_tto right) when wheels are posi-
tioned straight forward, remove steenng
wheel and reassemble per instructions/n
the Assembly section of this manual.
FRONT WHEEL TOE-IN ADJUSTMENT
Front wheel toe-in is required for proper
steering operation. Toe-in was set at the
factory and adjustment should notbe nec-
essary. Ifparts in the front axle or steering
mechanism have been replaced or dam-
aged, check toe-in and adjust if necessary.
TO CHECK TOE-IN
• Positionfront wheels straight ahead.
• Measure distance between wheels at
front and rear oftires (dimensions "A"
and "B').
• Front dimension "A" should be 1/8" to
1/4" less than rear dimension =B".
TO ADJUST TOE-IN
* Loosen jam nuts at adjustment sleeves
on tie rod.
• Adjust tie rod until dimension =A" is 1/8"
to 1/4" less than dimension =B".
• Tighten jam nuts securely.
FRONT WHEEL CAMBER
The front wheel camber is not adjustable
on your tractor. If damage has occurred to
affect the front wheel camber, contact your
nearest authorized service center/depart-
ment.
27
Loading ...
Loading ...
Loading ...