Loading ...
Loading ...
Loading ...
TO LEVEL MOWER HOUSING
Adjustthe mower while tractor is parked
onlevel ground ordriveway. Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS'). If tires are
over or underinflated, you will not propedy
adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• Measure height from bottom of deck
cud to ground level at front comers of
mower. Distance =A"on both sides of
mower should be the same.
• If adjustment is necessary, make adjust-
ment on one side of mower only.
• To raise one side of mower, tighten lift
linkadjustment nut onthat side.
• To lower one side of mower, loosen lift
linkadjustment nut onthat side.
NOTE: Each full tom of adjustment nut
willchange mower height about 3116".
• Recheck measurements after adjusting.
Bottom
Bottom
of Cud\_ f Curl
• Before making any necessary adjust-
ments, check that both front linksare
equal in length.
• If links are notequal in length, adjust
one link to same length as other link.
• To lowerfront of mower housing, loosen
nut "G" on both front links an equal
number oftums.
• When distance =F"is 1/8=to 1/2" lower
at front than rear, tighten nut "H" against
trunnion on both front links.
• To raise front of mower housing, loosen
nut =H"from trunnion on bothfront links.
Tighten nut =G"onboth front links an
equal number of turns.
• When distance =F"is 1/8' to 1/2" lower
at front than rear, tighten nut "H"
against trunnion onboth front links.
NOTE: Each full tum of nut =G" will
change dim. =F"by approximately 3/8".
• Recheck side-to-side adjustment.
Mandrel
Both Front LinksShould be Length
LiftLinkAdjustmentNut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side=re=
side. If the following front-to-back adjust-
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side=to-side.
To obtain the best cutting results, the
mower housing should be adjusted so the
front is approximately 1/8" to 1/2" lower
than the rear when the mower is in its
highest position.
Check adjustment on right side of tractor.
Measure distanc_ =F" directly in front of
and behind the mandrel at bottom edge of
mower, housing as shown.
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
• Park tractor on a level surface. Engage
parking brake.
• Remove screws from left hand mandrel
cover and remove cover.
• Roll belt over the top of left hand man-
drel pulley.
• Remove belt from electric clutch pulley.
: Remove belt fromidler pulleys.
Remove any dirt or grass clippings .
which may have accumulated arouna
mandrels and entire upper deck sur-
• face.
24
Loading ...
Loading ...
Loading ...