Loading ...
Loading ...
Loading ...
Three wire power supply cord must have
three, No.-10 copper wires and match a
three-wire receptacle of NEMA Type
I0-30R.
Three-wire receptacle
Where local codespermit
connecting cabinet-ground conductor to neutral wire:
4. Loosen or remove
block screw,
_. Connect the neutral wire
center) of power supply cord to the
center, silver-colored terminal screw of
the terminal block. Tighten screw•
6. Connect the other wires to outer _
terminal block screws. Tighten screws.
7, Tighten strain relief screws.
8. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover with
hold down screw.
OI
wire
reenter)
Where local codespermit
connecting cabinet-ground conductor 1o neutral wire:
4. Loosen or remove center terminal
block screw.
5. Place the hooked end of the neutral
wire (white or center) of power supply
cable under the center screw of the
terminal block (hook facing right).
Squeeze hooked end together. 7]ghten
screw.
6, Place the hooked ends of the other
power supply cable wires under the outer
terminal block screws (hook facing right).
Squeeze hooked ends together. Tighten
screws.
7. Tighten strain relief screws_•
8. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover with
hold-down screw.
I i
Three-wire power supply cord must have
three, No.-10 copper wires and match a
three-wire receptacle of NEMA Type 10-
SOR.
Direct wire power supply cab e mus be
prepared as shown in "Preparing the wire"
, of the three wire connection direct-wge
steps above.
Where local codesDo Notpermit
connecting cabinet-ground conductor to neutral wire:
9. After reattaching the terminal cover,
connect a separate copper ground wire from
4. Remove center terminal block screw, the external ground connector screw to an
adequate ground.
5, Remove the appliance harness ground
wire (green with yellow stripes) from the
external ground connector screw.
Connect appliance harness ground wire
and the neutral wire (white or center) of
the power supply cord/cable under the
center, silver-colored terminal block screw.
Tighten screw,
6. Connect the other wires to outer
terminal block screws, Tighten screws.
7, Tighten strain relief screws._
8,1nsert tab of terminal block cover into __ .If"'_f""
slot of dryer rear panel. Secure cover with _ _
hold-down screw, cover with
Panel E
Loading ...
Loading ...
Loading ...