Loading ...
Loading ...
Loading ...
PelPro Pellet Stove • 7103-171E • January 9, 2020
pelprostoves.com
27
Replacement Parts
Replacement Parts
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
Snap Disc
1. Turn the dial control to the o position. Unplug the
power to the appliance.
2. Using Phillips head screwdriver, loosen the bolts
on the rear of the appliance holding on the left side
panel (you do not need to remove the screws).
Remove side panels by lifting up and out.
3. Locate the snap disc on the top side of the feed tube
where it meets to the hopper. Disconnect the wire
leads from the snap disc.
4. Using a Phillips head screwdriver, remove two
screws retaining the snap disc on the side of the feed
tube.
5. Using the same screws, attach the new snap disc;
attach wire leads.
6. Restore power.
Replacement kit: SRV230-0080
Igniter
1. Turn the dial control to the o position. Unplug the power to the appliance.
2. Unplug the wire leads to the igniter.
3. Remove the screw in the side of the igniter chamber. Pinch the ends of the bracket
together and pull the igniter straight out of the igniter chamber.
4. If there is diculty in removing the igniter from the chamber, the chamber can be removed
from the rear of the rebox by removing the 1/4-20 bolts.
5. Re-install the new igniter into the chamber using the bracket.
6. Inspect the igniter from the front of the appliance by removing the repot and looking into
the end of the chamber (MAKE SURE The IGNITER IS CENTERED IN THE CHAMBER).
Replacement kit: SRV7000-660
Loading ...
Loading ...
Loading ...