Loading ...
Loading ...
Loading ...
37
EXHIBIT A
Correct Position for Dual Burner
Here’s the procedure to check the condition for our current burner design. The procedure helps
the electrode to sense the flame correctly.
1. Make sure the Burner Design is correct. Our current design for the burner is having the
electrode on the left side (10 o’clock) and cross-over on the right side (2 o’clock). There are four
parts for the dual burners. They are burner cap, flame ring base, flame ring and burner base.
2. Make sure the electrode is going through the hole on the flame ring and it is vertical to the
surface of flame ring base.
3. For the flame ring base part. make sure that the electrode will go through the hole on the 10
o’clock position. Make sure the electrode is not going through the hole next to the cross-over.
4. Make sure the electrode is vertical to the surface of the burner base. Please be notified that
there’s a slot at the 8 o’clock position of the burner base. This slot helps to locate the burner
732 South Racetrack Road, Henderson, Nevada 89015
in f o @ v in o t e m p . c o m
Loading ...
Loading ...
Loading ...