Loading ...
Loading ...
Loading ...
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-read engine repair establish-
ment or individual.Warranty repairs must
be performed by an authorized engine
manufacturer'sservice outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttlecentrol has been preset at the
factory and adjustment should not be
necessary. Check adjustmentas de-
scdbed below before loosening cable. If
adjustment is necessary,proceed as
follows:
1. With engine notrunning, move throttle
control lever to fast position.
2. Check that speed controllever is
against stop screw. If itis not, loosen
casing clamp screw and pull throttle
cable until lever isagainst screw.
Tighten clamp screw securely.
Idle Fuel Adjusting Idle speed Adjusting
Screw
Throttle
Control
Cable
Screw Clamp Screw
Choke Control Cable
TO ADJUST CHOKE CONTROL
The choke controlhas been preset at the
factory and adjustment should not be
necessary, check adjustment as de-
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (See =AIR FILTER" in the
Maintenance section of this manual).
3. Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable untilchoke iscompletely
closed. Tighten casing clamp screw
securely.
4. Reassemble air cleaner.
Closed for Full
TO ADJUST CARBURETOR
The carburetor has been present at the
factory and adjustment should not be
necessary. However, minor adjustment
may be required to compensate for
differences in fuel, temperature, altitude
or load. If the carburetor does need
adjustment, proceed as follows:
In general, turning the adjusting needles
in (clockwise) decreases the supplyof
fuel to the engine giving a leaner fuel/air
mixture. Turningthe adjustingneedles out
(counterclockwise) increases the supply
offuel to the engine givinga richerfuel/
air mixture.
IMPORTANT: Damage to the needles
and the seats in carburetor may result if
screw is turned in too tight.
PRELIMINARY SETTING -
1. Be sure you have a clean air filter, and
the throttle control cable is adjusted
propedy (see =TOADJUST
THRO]3-LE CONTROL CABLE" in the
Service and Adjustments sectionof
this manual).
2. With engine off tum idle fuel adjusting
needle In (clockwise) closingit finger
tight and then turn out (counterclock-
wise) 1 tum.
FINAL SETTING -
1. Start engine and allow to warm for five
minutes. Make final adjustments with
engine running and shift/motion
control lever in neutral (N) position.
31
Loading ...
Loading ...
Loading ...