Craftsman 917275223 lawn tractor

User Manual - Page 19

For 917275223.

PDF File Manual, 64 pages, Download pdf file

Loading ...
Loading ...
Loading ...
NOTE: Beforestarting,readthe warmand
coldaiart_gprucedumsbaiow.
6, Insert key into ignitionand rum key
clockwiseto =START" position and
release key as soon as engine starts.
Do not run starter continuouslyfor
more than fifteen seconds per minute.
If the engine does not start after
several attempts, push choke control
in, wait a few minutes end try again, if
engine stilldoes not start, pull the
choke control out and retry.
WARMWEATHERSTARTING(50° F and
above)
7. When engine starts, slowly push
choke control in untilthe engine
begins to run smoothly. If the engine
startsto run roughly,pull the choke
control out slightlyfor a few seconds
and then continueto push the control
in slowly.
The attachmentsand groundddvecan
nowbe used.If_ enginedoesnotaccept
thoIoed,rostarttbeengineand allewit to
warmupforcoe minete usingthe choke
as dascri_edabove.
COLDWEATHER STARTING(50° F and
_w)
7. When engine starts, slowly push
choke control in until the engine
begins to run smoothly. Continue to
push the choke control in small steps
allowing the engine to accept small
changes in speed and load, untilthe
choke contrel is fully in. If the engine
startsto runroughly,pull the choke
control out slightlyfor a few seconds
and then continue to push the control
in slewty.This may require an engine
warm-up period from several seconds
to several minutes, depending on the
temperature.
NOTE: In extreme cold conditions,if
engine will notstart you may need to
disengage the motion drive belt as
follows:
1. Be sure parking brake is engaged.
2. Remove retainer spdng from the drive
belt tension handle to relieve belt
tension.
3. Start engine and allow it to warm up
for three (3) minutes.
4. Shut-off engine and engage parking
brake.
5. Engage drive belt tension handle and
replace the retainer spring.
AUTOMATICTRANSMISSION WARM UP
Before ddving the unit in cold weather,
the transmission should be warmed up as
follows:
1. Be sure the tractor is on level ground.
2. Place the motioncontrol lever in
neutral. Release the parking brake
and letthe brake slowly returnto
operating position.
3. A_ow one minute for transmission_.o
warm up. This can be done dudng the
engine warm up peded.
The attachments can be used dudng
the engine warm-up podod after the
transmission has been warmed up and
may require the choke controlbe
pulled out slightly.
NOTE: If at a high altitude (above 3000
feet) or in cold temperatures (below 32 F)
the carburetor fuel mixture may need to
be adjusted for best engine performance.
See =TOADJUST CARBURETOR" in the
Service and Adjustmentssection of this
manual.
PURGETRANSMISSION
,_LCAUTION: Never engage or disen-
gage freewheel lever while the engine is
running.
To ensure proper operation and perfor-
mance, it is recommendedthatthe
transmissioobe purged before operating
tractorforthe firsttime.This procedurewill
removeany trapped air insidethe trans-
missionwhich may have developed dudng
shipping ofyour tractor.
IMPORTANT: Should yourtransmission
require removal for service or replacement,
it should be purged after reinstallation
before operatingthe tractor.
1. Place tractor safely on level surface
with engine off and parking brake set.
2. Disengage transmission by placing
freewheel control in freewheeling
position (See "TO TRANSPORT" in
this section of manual).
3. Sittingin the tractor seat, start engine.
After the engine is running, move
throttle control to slow position.
Disengage parking brake.
4. Move motion control lever to full
forward position and hold for five (5)
seconds. Move lever to full reverse
positionand hold for five (5) seconds.
Repeat this procedure three (3) times.
NOTE: Dudng this procedurethere willbe
no movement of drivewheels. The air is
being removed from hydraulledrive
system.
19
Loading ...
Loading ...
Loading ...