Loading ...
Loading ...
Loading ...
Using the Wa//-IVIounted Door Control To Open the Door IVlanua/ly
THEMOTION DETECTINGCONTROLCONSOLE
Press the push bar to open or close the __11
door. Pressagain to reversethe door during _Push
the closing cycle or to stop the door while _ Bar
it's opening. Lock
This door control contains a motion detector _j_Button
that will automatically turn on the light when iiI_"Light
it detects a person entering the garage. This _j Button
feature can be easily turned off for extended
work light use.
Light feature
Press the Light button to turn the opener light on or off. It will not
control the opener lights when the door is in motion. If you turn it
on and then activate the opener, the light will remain on for 4-1/2
minutes. Press again to turn it off sooner. The 4-1/2 minute
interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as
follows: Press and hold the Lock button until the light blinks
(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeatthe procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat againfor a
3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
Lockfeature
Designedto prevent operation of the door from hand-held remote
controls. However,the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push button light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push button light will stop flashing. The Lock feature will also
turn off wheneverthe "learn" button on the motor unit panel is
activated.
Additionalfeature when usedwith the 3-Functionhand-held
remote
To control the opener lights:
In addition to operating the door, you may
program the remote to operate the lights.
1. With the door closed, press and hold a
small remote button that you want to control the light.
2. Pressand hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock button
on the door control.
4. After the opener lights flash, releaseall buttons.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garagedoor:
• If possible, use emergency releasehandle to disengage
trolley ONLYwhen garagedoor is CLOSED.Weak or broken
springs or unbalanceddoor could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
DISCONNECTTHE TROLLEY:
The door should be fully closed if
possible. Pull down on the
emergency releasehandle (so that
the trolley releasearm snaps into a
vertical position) and lift the door
manually. The lockout feature
prevents the trolley from
reconnecting automatically, and the
door can be raised and lowered
manually as often as necessary.
TO RE-CONNECTTHETROLLEY:
Pull the emergency release handle
toward the opener at an angle so
that the trolley releasearm is
horizontal. The trolley will
reconnect on the next UP or DOWN
operation, either manually or by
using the door control or remote.
Trolley
Trolley -- ._._
Release Arm
(In Manual
Disconnect
Position)
Lockoutposition
(Manual disconnect)
Trolley
Emergency ". _Arm
Release Handle _ "_ ._
(Down and Back)_'
TOreconnect
31
Loading ...
Loading ...
Loading ...