Loading ...
Loading ...
Preparingyourgarage door
Before you begin:
• Disable locks.
• Removeany ropes connected to garage door.
• Completethe following test to makesure your garage door is
balanced and is not sticking or binding:
1. Lift the door about halfway as shown. Releasethe door. If
balanced,it should stay in place, supported entirely by its
springs.
2. Raiseand lower the door to see if there is any binding or
sticking.
If your door binds, sticks, or is out of balance, call a trained door
systems technician.
SectionalDoor
To prevent possible SERIOUSINJURYor DEATH:
• ALWAYScall a trained door systems technician if garage
door binds, sticks or is out of balance. An unbalanced
garagedoor may not reversewhen required.
• NEVERtry to loosen, move or adjust garage door, door
springs, cables, pulleys, brackets or their hardware,ALL of
which are under EXTREMEtension.
• DisableALL locks and remove ALL ropes connected to
garagedoor BEFOREinstalling and operating garagedoor
opener to avoid entanglement.
To prevent damageto garage door and opener:
• ALWAYSdisable locks BEFOREinstalling and operating the
opener.
• ONLYoperate garagedoor opener at 120 V, 60 Hz to avoid
malfunction and damage.
One-Piece Door
Tools needed
During assembly, installation and adjustment of the opener,
instructions will call for hand tools as illustrated below.
Stepladder
Level (optional)
Pencil
Tape Measure
Dr_ Wire Cutters
Drill 3/16", 5/16"
_[_} and 5/32"
1/2", 5/8", 7/16", 9/16" Pliers
and 1/4"
Hack Saw
Claw Hammer
Screwdriver
Adjustable End Wrench
Loading ...
Loading ...
Loading ...