Loading ...
Loading ...
Loading ...
22
i. “On/Off” When set to off, the Chorus input is disabled. This allows the current signal to “ring out”
until the current Chorus signal is completed. To end the Chorus process result immediately, turn
down the Chorus Level to Mix fader.
ii. “Reset” will set the Chorus processing settings to default settings.
iii. “Presets” offers users a quick selection of common setting combinations for fast selection in typical
use cases. These Chorus presets are named as descriptions of the types of common musical uses
they simulate. The user can select “Custom” and adjust all the settings themselves. Or they can
start with recalling one of the presets, listen, and then add any settings adjustments, which will
automatically load the new combination of settings into the “Custom” setting for further editing.
. Custom
. Slow Light
. Slow Deep
. Fast Light
. Fast Deep
. Smooth Vibrato
. High Pass
. Medium Narrow
iv. “Rate” adjusts the speed of vibration of the chorus effect.
v. “Depth” adjusts the length of time the chorus process takes to ring out over time.
vi. “Width” adjusts how wide the chorus process resonates above the source frequencies.
vii. “Level to Mix” is the amount of the Chorus signal sent to the FX Return fader, which then contributes
to the nal mix.
. To adjust any parameter, navigate to the parameter using the MASTER/MENU knob. Press the
MASTER/MENU knob to access.
. Adjust the values by turning the knob CLOCKWISE or COUNTER-CLOCKWISE.
. Press the MASTER/MENU knob to accept these changes. Press the BACK button to cancel
these changes.
e. Subsynth - The FX Processing SubSynth generates a complimentary bass note one octave below the
current input music. The SubSynth effect is often used on music to add a very deep low frequency bass
effect in line with the musical source feeding the SubSynth processor, instead of a general raise in bass EQ
frequencies using EQ bands. SubSynth is relative to the incoming musical content.
i. “On/Off” turns on/off the input to the SubSynth processor.
ii. “Level to Mix” sets how much of the SubSynth result is fed to the FX Return fader, which then feeds
the master mix fader.
iii. To adjust any parameter, navigate to the parameter using the MASTER/MENU knob. Press the
MASTER/MENU knob to access.
. Adjust the values by turning the knob CLOCKWISE or COUNTER-CLOCKWISE.
. Press the MASTER/MENU knob to accept these changes. Press the BACK button to cancel
these changes.
Loading ...
Loading ...
Loading ...