Loading ...
Loading ...
Loading ...
15
CH 1-2
• Phantom Power disclaimer
When using condenser microphones, +48V phantom power is required to be present at the contacts of the
microphone (XLR) connector for the microphone to operate correctly. When phantom power is enabled, it is applied to
both the CH1 and CH2 XLR inputs. Ensure that phantom power is off when not required.
To prevent damage to the PRX ONE or external devices when using condenser microphones, always turn down all PRX
ONE output controls and ensure the +48V phantom power is off before connecting the microphone. Once the condenser
microphone has been connected, enable the +48V phantom power, then raise the output controls to the desired levels.
1. The PRX ONE offers user-selectable phantom power on both channels 1 and 2, turned on via the LCD or the APP.
a. To engage phantom power, press the knob for CH1 or CH2 to open the Channel Menu.
b. Navigate to Phantom Power and press the Master/Menu knob.
Knobs and Functions
The PRX ONE comes equipped with push-button rotaries to make for easy navigation and hardware usage.
1. A single press of a Channel knob will activate CHANNEL STRIP MODE for that channel.
a. Please see the section on CHANNEL STRIP MODE for more clarity.
2. Pressing and holding a CH knob for 2s at any time will mute that channel. Channel LED below muted channel will
slowly ash RED.
3. A single press of the MASTER/MENU knob will open up the master menu, unless you are in a channel menu
screen. In channel menu screens, the MASTER/MENU knob controls your main navigation through these screens.
4. Pressing and Holding MASTER/MENU while on the home page will mute the speaker.
L. 6.35mm Hi-Z Balanced Input
Two female 6.3mm connectors (1 for each input) are used for the analog audio inputs.
M. 3.5mm Stereo Un-Balanced Input
Two channel single ended input, mono mixed as a single mixed channel.
N. XLR Male Pass Thru
This XLR (male) output connector provides a method of sending audio out to an external source. If signal is present on all inputs, the
inputs will be summed and sent out as a mix: Can be adjusted in the pass through menu section.
Loading ...
Loading ...
Loading ...