Loading ...
Loading ...
Loading ...
PAGE: 6 / 11
F A N C O
181008
Hanger Pin
Sollar Screw
Fig.7
Fig.8
Collar
Lock Pin
Hanger
Pin
Collar Screw
Downrod
Loosen the collar screws in part
way. Insert the downrod into the collar.
Slide hanger pin through holes of
collar and downrod.
Insert and tighten the two collar
screws. Slide lock pin into hanger pin
until it is locked into position.
Hang the fan on hanger bracket,
and make sure the slot of hanger
ball is snapped into the chip of
hanger bracket exactly.
Note: For slope ceiling
installation, make sure the slot
of hanger ball and the chip of
hanger bracket face down.
Slot
Chip
Hanger Bracket
Fig.9
Code example:
1-ON 2-OFF 3-ON 4-OFF on both
DIP Switches.
Note: If you have two ceiling fans
with 2 remote control units, set 2
different codes for each set of
transmitter / receivers.
Fig.10
Antenna
DIP Switch
Transmitter
Receiver
Fig.10a
There is a code switch in the transmitter
and receiver. This "DIP Switch" is a 4 key
unit (Fig.10). All keys were set at "ON"
position in the beginning. Set the keys to
a different code. Make sure the same
numbered keys are switched "ON" for
both DIP Switches (Fig.10a). Take note
that the "ON" position may have different
orientation in each.
Fig.11
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Antenna
Receiver
Hanger Bracket
a.
b.
c.
Loading ...
Loading ...
Loading ...