Loading ...
Loading ...
Loading ...
PAGE: 5 / 11
Installation Steps :
Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
F A N C O
181008
NOTE: The fan weight is 23.8 lbs (10.8 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failing to do so can result in serious injury.
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION ON THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
Tighten the hanger bracket to the outlet box with two mounting screws.(Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling with the dry wall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
Fig.5.Fig.2.
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Washer
Safety Cable Hook
Dry Wall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.3
Housing Screw
Motor Cover
Motor Cover
Blade Screw
Motor Wires
Motor Wires
Screw Plate
Remove six housing screws, take care not to
drop the screws or washers into the fan
housing. Push the motor cover upward, and
slide down the motor wires and the safety
cable until they are out of the way.
Fig.4
Housing Screw
Slot
Blade
Motor
Screw Plate
Remove the blade screws and washers from motor. Insert
the blade through the slot on the motor. Align holes and
fasten blade to the motor with blade screws and washers.
Repeat for remaining blades. After all blades are fastened
securely to the motor, restore the motor cover and screw
plate onto the motor and fasten it with six housing screws.
Safety Cable
Safety Cable
Safety Cable
Washer
Thread the motor wires
and safety cable through
the downrod stand cover,
downrod stand cover
decoration, decorative cap,
canopy and the downrod.
Downrod
Hanger Pin
Lock Pin
Remove the lock pin and take off
the hanger pin.
Fig.5
Fig.6
Motor Wires
Downrod
Stand
Cover
Downrod
Stand
Cover
Decoration
Decorative Cap
Canopy
Collar
Loading ...
Loading ...
Loading ...