Loading ...
Loading ...
Loading ...
13
A
C
B
4. If you are installing your keg refrigerator under a coun-
ter you will need to drill 5 holes in the counter top to
mount the tower. The rst hole is a 1
1
⁄2" diameter hole
located at the center of the tower for the beer line, lo-
cate approximately 13
1
⁄2" (34.3 cm) from the front edge
of the counter top (based on a counter top depth of
25
5
⁄16"). Next drill the 4 tower mounting holes per the di-
mensions in Figure 29. The hole diameter is dependent
on the counter top material and if screw anchors are
required. The screws supplied are in the literature pack
and are a #10 x 1" type AB stainless steel screw. Mark
and cut the rectangular cutout for the drain sump. After
the holes are drilled and the keg refrigerator is in place
under the counter top feed the beer line through the
tower gasket, the 1
1
⁄2" hole in the counter top and the
hole in the top of the keg refrigerator. Mount the tower
to the counter top with the 4 screws provided. Place
the counter top drain sump, from the literature pack, in
the rectangular hole with the radius cutout to the rear
around the tower and place the grate in the sump.
5. Mount the regulator to the CO2 tank (connection ).
Note that the regulator has left hand threads and has to
be turned counterclockwise to tighten. Tighten with the
adjustable wrench or the 1
1
⁄8" open end wrench.
6. Connect the red air line(s) from the regulator to the
large air line tting on the keg coupler with a large
hose clamp (connection ).
7. Connect the clear beer line from the tower to the small
air line tting on the keg coupler with a small hose
clamp (connection ).
8. Locate the CO2 tank in the corner of the refrigerator as
shown in Figure 32 and secure with the chain. Close
the faucet handle on the tower.
Diameter
to suit
Rear of counter top
6
1
⁄8"
(15.6 cm)
12
1
⁄4"
(31.1 cm)
2
7
⁄8"
(7.3 cm)
4
1
⁄4"
(10.8 cm)
6
3
⁄8"
(16.2 cm)
1
3
⁄8"
(3.5 cm)
typical
1
1
⁄2 (38 mm)
Diameter
counter
top depth
25
5
⁄16"
(64.3 cm)
1
⁄4" (6 mm)
radii,
typical
Figure 29
Figure 30
Figure 31
Grate from top of
beer dispenser
Counter top
sump from
literature pack
Tower
!
CAUTION
The cutout dimensions shown in Figure 29 are based on
a 25
5
⁄16" (64.3 cm) deep counter top. Your counter top may
be different than this and require other front to back dimen-
sioning. Refer to the product dimensions on page 8 when
determining the required dimensions.
USING YOUR BEER DISPENSER
Loading ...
Loading ...
Loading ...