Loading ...
Loading ...
Loading ...
• Lay bagger cover upside - down (leave
protective covering intact),.
. Slide bagger handle insert (9) into
depression on inside of bagger cover,.
Make sure the two tabs at the top
lock into place with the bagger cover.
Teeth at the bottom of the bagger'
......................handle insert should slide into place in
between the teeth on the bagger cover,
. Slide two square nuts (10) into the two
square slots at the front of the bagger
cover and two square nuts into the two
square slots (one slot on each side) at
..........................the- rear-, handle of the- bagger cove[:
. Turn bagger assembly (3) upside
down, lining up holes in the frame to
holes in the bagger cover, making sure
frame upper weldment tubing is seated
in plastic cradle in the bagger handle
insert (9).
• Install four 1/4" hex bolts (!1) in holes
with four square nuts (10) and tighten
until seated°
• Install two 1/4" screws (12) in holes at
center of frame upper weldment.
, Turn assembly right- side up.
° Install two 1\4" carriage bolts (13) at
bottom of front bagger frame (I4), hand
tightening lock nuts (15).
. Feed front bagger frame (14) up
through fabric loops at front of bagger.
• Snap bottom of front bagger frame (14)
into snap feature at front of bagger
bottom.
• Slide bagger fabric loop segments at
the ends of bag onto top bagger frame
tubing.
• Slide two 1\4" hex bolts (16) through
holes at top of the front bagger frame
and thread into nuts inside the tubing of
top bagger frame..
• Slide plastic clip (17) down into bagger
fabric loop on right side and snap to front
bagger frame (I4) 101 mm (4 inches)
from top of front bagger frame tube.
° Uninstall lock nuts (21) at rear of top
bagger frame and at bottom of front
bagger frame and attach cross braces
(22) on each side.
• Reinstall lock nuts (21) and tighten until
fully seated.
• Slide rubber seal (23) to top of metal
bagger handle (24).
• Slide bagger handle (24) down through
bagger cover and frame upper weldment
holes.
• Slide clevis pin (25) through hole at
bottom of bagger handle and slide
retainer spring (26) into hole at the end
of the clevis pin until it locks into place
PARA NIVEL
Aseg_rese de
ta PSI que se i
inflados o poc
bien cortado,
la SEGADOR
REGULACIO
1. Sitodoslc
inflados y
codado dq
cortadora
2. Con una
regulabte
tuerca de
para bajaJ
h&gala gil
para subi_
NOTA: Cada
ajuste her& va
madamente 3
Haga girar la
tuerca f_acia!
la derecha
paresubir4a
segadora_
3. Pruebe I_
c6sped q_
vando co
case nec,
satisfact#_
REGULAClOI
A LADO
1. Con todo
inflados, e
o en la en
CUIDADO:
las manos co_
con tela grue.,
2o Suba la S
3. A ambos
cuchilla h_
que hay e
y el suelo.
a ambos I
4,. En caso q_
lea los pa_
laci6n Vis_
10
Loading ...
Loading ...
Loading ...