Loading ...
Loading ...
Loading ...
15
Parts Removal & Replacement
Grill Burner:
- Remove top grates.
- Remove shields.
- Remove cotter pin on the bottom rear of each burner and slide out.
- Clean and replace in reverse order.
Main Burner Electrode:
Remove front panel.
- Unscrew the electrode bracket from the valve.
- Disconnect wire from the valve.
- Replace in the reverse order.
Rotisserie Electrode:
- Remove electrode cover – lift and pull.
- Remove electrode screws and pull out.
- Disconnect wire at rear.
- Replace in reverse order.
Switch:
- Remove front panel.
- Disconnect wire from switch at rear.
- Remove retaining nut and push switch from rear of the panel.
- Replace in reverse order.
Troubleshooting
Problem Solutions
Burner will not light - Check gas supply to burner by manually lighting the burners.
- Check pilot side of valve for spark while gas is off.
- Make sure spark area is clean from debris, spider webs etc.
- Make sure you now have spark.
- If no spark, check valve for defects, and replace if needed.
Improper burner flame - Check burner gas inlet area for blockage
- Check orifice hoods for any clogging and clean.
- Adjust air shutter, if necessary.
- Check pressure if flame is too low or too high.
- Check gas supply tank (LP) if running low.
Light is not ON - Connect 115V power at rear. Turn switch ON.
- Make sure the transformer was used in installation and your grill was NOT
hooked up directly to 115 volt power source.
- Check bulb and replace if necessary.
Loading ...
Loading ...
Loading ...