Loading ...
Loading ...
Loading ...
9
Fuel Conversion (Burners)
1. Determine the existing gas type. (LP or Natural gas) Changing the gas type and orifice change out is the
same for both gases.
2. You must remove all grates and burner covers to expose the main burners in the grill.
3. On the bottom rear of each burner is a cotter pin. Remove cotter pin.
4. Slide burner to the rear of the grill and up. Repeat for each burner.
5. Where the burner was located going through a hole in the basin and connecting to the valve is now
evacuated space.
6. Inside the space you will find the end of the valve (front of grill), with an orifice (brass fitting), screwed
into the end of the valve body.
7. Remove the orifice with a socket set and extension. These are extremely fragile when removing. Take
extra precaution when removing.
8. Replace with LP orifice supplied in the kit, (repeat for all burners). When re-installing orifice do not over
tighten or you will strip and or break the brass orifice. Minimal torque is required when tightening!
9. Replace burners and test for proper flame color and height. The flame should be blue in color with small
yellow tips. The flame height should be at ½” to 1” on low and 1.5” to 2” on high. The low flame setting
may need to be adjusted after converting the grill to LP. Please refer to step 11 listed below to adjust the
low flame setting.
10. Replace burner covers and grates.
Low Flame Set Screw
11. If necessary, adjust the low flame set screw located behind the burner
control knob on the front of the valve. Back the screw out until it is flush
with the valve body.
Note: It may be necessary to adjust the air mixture on each burner after a
conversion. Typically LP gas requires more primary air so open the air mixers
to at least half open. The opposite is true for natural gas. In some cases close
these air mixer adjusters completely.
Rotisserie Burner Conversion
12. Remove the back panel at the rear of the grill, this
will expose the V shaped or pyramid shaped brass
orifice.
13. Remove the existing orifice and replace with change
out orifice.
14. Replace rear panel
Loading ...
Loading ...
Loading ...