Loading ...
Loading ...
Loading ...
6
Electrical connection
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician and carried out according to
instructions provided by the manufacturer. Incorrect installation might cause harm
and damage, for which the manufacturer accepts no responsibility.
Electrical Installation
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and the
mains electric wiring should be capable of handling the oven’s power rating (also indicated on the identification
plate). If you have any doubts, call in a qualified technician.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points as these
may overheat and catch fire. Do not install separate timers.
After having installed the appliance, the switched outlet must always be in an accessible position. The electrical
safety of this appliance can only be guaranteed if the cooktop is correctly and efficiently earthed, always ensure that
the earthing is efficient; if you have any doubts call in a licensed electrician to check the system. The manufacturer
declines all responsibility for damage resulting from an installation which has not been correctly earthed.
WARNING: If any damage occurs to the power cable during or after installation, it must be replaced immediately by
a licensed electrician with a replacement cable from your Service Centre.
The cooktops are to be connected to a single phase 220-240Vac 50 Hz supply.
The appliance is designed for fixed connection to the mains. Means for disconnection with a suitable - isolating
switch must be incorporated in the fixed wiring in accordance with the wiring rules. The power supply cord must not
touch against any hot surfaces and must be placed so that its temperature does not exceed 75 °C at any point along
its length.
Wire cross-sectional
area
Connection mode
L
N
PE
Single phase 1N~
Minimum 2.5mm
Minimum 2.5mm
Minimum 2.5mm
Loading ...
Loading ...
Loading ...