Loading ...
Loading ...
Loading ...
CONVERSION TO OPERATE ON ULPG
This must be done by a licensed Gas Fitter. COMPULSORY REQUIREMENT
Included with the cooker is a conversion kit for converting the cooker to operate on ULPG (LPG
in Aust.). The kit consists of replacement injectors for all burners, including oven burner for gas
models. The kit also includes a test point for checking gas pressure and a replacement label
identifying the type of gas the cooker is connected to.
There is no gas regulator requirement for ULPG installations as the gas pressure of 2.75 Kpa is
regulated at the bottle.
A 7 mm socket is needed to remove and replace the injectors. The data plate in this instruction
manual identifies the injector size for each burner.
Each burner must be run on the minimum flame setting and adjusted accordingly to ensure that
the minimum flame is not extinguished by air drafts.
When completing the LPG conversion the
bypass screw on the oven thermostat needs to
be screwed all the way clockwise.
Use a small flat blade screwdriver.
REMEMBER TO CHANGE THE OVEN INJECTOR ON GAS OVEN COOKERS.
If the flame is yellow and leaves black marks on pots and in the oven then the conversion has not
been done correctly. THIS WILL VOID THE WARRANTY.
ALL CONVERSIONS TO ULPG MUST BE CARRIED OUT BY A LICENSED GAS FITTER. GLEM
GAS WARRANTY SERVICE WILL NOT BE MADE ON INCORRECTLY CONVERTED APPLIANCES.
NOTE!
STANDARD PLUMBERS TEFLON TAPE SHOULD NOT BE USED TO SEAL JOINTS.
AN APPROPRIATE GAS SEALING TAPE MUST BE USED.
GAS CHECKS AND ADJUSTMENTS - LOW FLAME SETTING
Check the low flame setting for each hob burner and the oven burner with the control engaged
in the minimum position.
Cooktop Burner -
Turn the control until it engages in the minimum position and remove the control knob. Insert
a screwdriver in the adjusting screw (located to the side of the gascock shaft). To increase the
flame, turn the adjusting screw anticlockwise. To decrease the flame, turn the adjusting screw
clockwise. Adjust for a minimum, stable and clear flame.
ENSURE THE MINIMUM FLAME WILL NOT BE EXTINGUISHED BY AIR DRAUGHTS.
Oven Burner -
Light the oven burner and operate at maximum for 15 minutes. Turn the control until it engages
in the minimum position and remove the control knob. Insert a screwdriver in the adjusting screw
(located to the left side of the thermostat shaft). To increase the flame, turn the adjusting screw
anticlockwise. To decrease the flame, turn the adjusting screw clockwise. Adjust for a minimum,
stable and clear flame.
Ensure the minimum flame will not be extinguished when the oven door is closed
23
Loading ...
Loading ...
Loading ...