Loading ...
Loading ...
Loading ...
12
Setting Surface Controls
O
F
F
L
O
Push in
T
u
r
n
Operating the Turbo Boil Flex Twin Burner
1. Place cooking utensil on surface burner.
2. Push the surface control knob down and turn
counterclockwise out of the OFF position (See Figure 1).
3. Release the knob and rotate to the Lite position.
4. Visually check that both the inner and outer rings for
the Twin burner are lit (See Figure 3). Once lit, turn the
control knob and continue to turn counterclockwise out
of the Lite position and adjust to the desired ame size.
5. When adjusting for a low or simmer type ame setting,
continue to rotate the control knob counterclockwise from
MED setting towards LO (See Figure 1). Between the MED
and LO settings, the ame for the outer ring portion of
the burner will turn o leaving only the inner burner with
a ame for simmering (See Figure 4). Make any further
ame adjustments as needed.
Figure 1 - Twin Burner Control
Figure 2 - Twin Burner
Figure 3 - Inner and Outer rings lit
Figure 4 - Inner ring only lit
Important notes:
• DO NOT cook with the surface control knob left in the
LITE position. (The electronic ignitor will continue to spark
if the control knob setting remains in the LITE position).
• When setting any surface control knob to the LITE
position, all electronic surface ignitors will spark at the
same time. However, only the surface burner you are
setting will ignite.
• NEVER place or straddle a cooking utensil over two
dierent surface cooking areas at the same time. This
can cause uneven heating results.
Setting the Turbo Boil Flex Twin Burner
The versatile Turbo Boil Flex Twin burner oers a complete
range of gas surface settings from the same burner position.
At the lowest setting, only the burner’s inner ring is active,
providing a smaller ame that is perfect for simmering. If
needed, the burner’s outer ring may be added and when set
for HI will provide a gas ame that may be used to bring a
large pan of liquid to boil quickly.
Loading ...
Loading ...
Loading ...