Loading ...
Loading ...
Loading ...
tro Abe hoot ncj
TROUBLESHOOTING
Samsung works hard to ensure that you don't have problems with your new electric range. If you run into
unexpected trouble, look first for a solution in the table below. If, after trying the suggested solution, you're
still having trouble, call Samsung at 1-800-SAMSUNG (1-800-726-7864).
The range is not The appliance has been installed
level, improperly.
The floor is sagging or sloping.
The kitchen cabinets are not
properly aligned and make the
range appear to be not level.
The appliance The kitchen cabinets are not
must be accessed square and built too tightly in to the
for servicing and appliance.
cannot be moved Carpet is interfering with
easily, movement of the range.
The oven control You have a function error code.
beeps and displays
n F error code. _USE
-SE= Shorted key
E-27 Oven sensor opened
E-28 Oven sensor shorted
E-g8 Oven heating error
E=OA Oven heating over
E-OE Door locking error
The surface units Improper cookware is being used.
will not maintain
a rolling boil or In some areas, the power (voltage)
will not cook fast may be low.
enough.
The surface units A fuse in your home may be blown
will not turn on. or the circuit breaker tripped.
The eooktop controls are set
improperly.
The surface unit
stops glowing when
changed to a lower
setting.
,, Place the oven rack in the center of the
oven. Place a level on the oven rack.
Adjust the leveling legs at the base of the
range until the oven rack is level.
Insure the floor is level and strong and
stable enough to adequately support the
range.
,, Contact a carpenter to correct the
situation.
Insure the cabinets are square and provide
sufficient room for installation.
Contact a builder or installer to make the
appliance accessible.
Provide sufficient space so the range can
be lifted over the carpet.
Press the CLEAR/OFF pad and restart
the oven. If the problem persists,
disconnect all power to the range for at
least 30 seconds and then reconnect the
power. If this does not solve the problem,
call for service.
,, Use pans which are flat and match the
diameter of the surface unit selected.
,, Cover the pan with a lid until the desired
heat is obtained.
,, Replace the fuse or reset the circuit
breaker.
,, Check to see the correct control is set for
the surface unit you are using.
This is normal. The unit is still on and hot.
Troubleshooting 54
NE595ROABSR_AA_DG68-00433A-06_EN.indd 54 06/03/2015 14:30:54
Loading ...
Loading ...
Loading ...