Loading ...
Loading ...
Loading ...
Installation Instructions
I-T1INSTALL THE ANTI-TIP DEVICE (cont.)
[] For wood construction, drill a pilot hole at an
angle of 20° from the horizontal. A nail or awl
may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, you
will need a 1/4" x 1V2" lag bolt and a 1/2" O.D.
sleeve anchor, which are not provided. Drill the
recommended size hole for the hardware.
Wallboard Back of
range
screw
Install the sleeve anchor into the drilled
hole and then install the lag bolt through the
device. The bolts must be properly tightened
as recommended for the hardware.
i-_ Slide the range against the wall, and check for
proper installation by grasping the front edge
of the cooktop and carefully attempting to tilt
the range forward. The bracket should stop
the range within/4 inches. If it does not, the
bracket must be reinstalled.
WHEN ALL HOOKUPS ARE COMPLETED
Hake sure all controls are left in the OFF
position. Make sure the flow of combustion and
ventilation air to the range is unobstructed.
CONVERTTO LPGAS(or convert back to
natural gas from LP)
This range leaves the factory set for use with
natural gas. If you want to convert to LP gas, the
conversion must be performed by a qualified LP
gas installer.
The conversion instructions and LP orifices can be
found attached to the range next to the pressure
regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.
42
Loading ...
Loading ...
Loading ...