Pleasant Hearth 321-42-10 42" Flat Wall Mount Electric Fireplace with Stand

User Manual - Page 7

For 321-42-10.

PDF File Manual, 36 pages, Read Online | Download pdf file

321-42-10 photo
Loading ...
Loading ...
Loading ...
7
Planning Installation
Before you begin assembly, locate the instructions and hardware. Compare all parts with the
Hardware Included and Package Contents lists. Be sure you have all the parts and can identify them.
A helping hand is always good. Assemble your replace with an adult assistant if possible.
Some pieces are heavy and will need to be held by a helper. Assembly time will take approximately
5-20 minutes.
Before assembly, use scissors to unwrap the parts from the packaging. Do not use a box cutter or
exacto-knife, as you may cut into the heater pieces inside the box and damage the nish. Check
for the hardware bag located inside the packaging, taped to the top of the box. Do not discard any
pieces. Use an appropriate screwdriver to insert and tighten all screws.
Electrical Connection
Grounding Instructions
A 15 Amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this
appliance. Preferably, the appliance will be on a dedicated circuit, as other appliances on the same
circuit may cause the circuit breaker to trip or the fuse to blow when the replace is in operation.
The unit comes standard with a 6 ft (1.8 m) long 3-wire cord, exiting out the back of the replace.
Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must
be a minimum No. 14 AWG, 3-wire with grounding type plug and connector, and must be rated not
less than 1875 watts. The extension cord shall not be more than 20 ft (6 m) in length.
This heater is for use with 120 volts. The cord has
a plug as shown at (A) in Figure 1. An adapter as
shown at (C) is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The
green grounding lug extending from the adapter
must be connected to a permanent ground such as
a properly grounded outlet box. The adapter should
not be used if a three-slot grounded receptacle is
available.
PREPARATION
CAUTION: This carton includes a GLASS panel! Always use extreme caution when
handling glass. Failure to do so could result in personal injury or property damage.
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of re, electrical shock, and injury to persons.
WARNING: Do not use this replace if any part of it has been under water. Immediately
call a qualied service technician to inspect the replace and replace any part of the
electrical system which has been under water.
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
A
B
C
NOTE: Adapters are NOT for use in Canada.
1
Loading ...
Loading ...
Loading ...