Loading ...
Loading ...
Loading ...
AUXILIARY FENCE/
WORK SUPPORT
/
CUTTING PANELS
When cutting panels (whenever fence is positioned outside
of table surface), ALWAYS use the AUXILIARY
F ENCE/WOR K SUPPORT.
1. Unlock fence and raise rear end.
2. Position AUXILIARY FENCE as shown and attach it
with two "C" clamps.
\
\
RABBETING
Rabbeting is known as cutting out a section of the corner
of a piece of material.
To make a RABBET requires two cuts which do not go all
the way through the material. Therefore the blade guard
must be removed.
1. Remove blade guard.
2. Adjust rip fence and blade to required dimensions.
3. Make first cut through edge. Follow resawing
procedure.
4. Remove auxiliary fence and make second cut.
5. INSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF RABBETING OPERATION.
Rabbet cuts can also be made using the dado head or
molding head.
RABBET
ADJUSTMENTS
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAKING ANY ADJUSTMENTS.
MITER GAUGE
NOTE: The graduations on the miter gauge provide
accuracy for average woodworking. In some cases where
extreme accuracy is required, when making angle cuts, for
example, make a trial cut and then recheck it with an
accurate square or protractor.
If necessary, the miter gauge head can be swiveled slightly
to corn pensate for any inaccuracy.
The HEAD should be SQUARE (90 ° ) with the bar when
the pointer points to "'0".
To check for squareness, place tan accurate square on the
miter guage. If the head is NOT SQUARE with the bar:
1. Loosen the lock knob.
2. Position the head square with the bar . . . tighten the
lock knob.
3. Loosen the screw and adjust the pointer, so it points to
zero.
The swiveling movement of the head can be adjusted by
tightening or loosening the set screw located in side of the
head using the 1/8 in. setscrew wrench.
23
Loading ...
Loading ...
Loading ...