Loading ...
Loading ...
Loading ...
ADJUSTING RIP SCALE POINTER
1. Turn ELEVATION crank counterclockwise until blade
is up ashigh asit will go.
IMPORTANT: BLADE must be SQUARE (90° ) to
TABLE, in order to ALIGN rip fence.
2. Position fence on right side of sawblade so that it
touches the sides of the teeth . . . tighten lock handle.
3. Loosen screw holding the pointer . . . adjust pointer so
that it points to "0"... tighten screw.
NOTE: If you cannot adjust pointer so that it points to
"0", loosen the screws holding the front guide bar and
move the guide bar.
LOCK HANDLE ""
INSTALLING BLADE GUARD
1. From among the loose parts, find the hardware as
shown.
SQUARE NUT i_:_:::::=_ _SPREADER SUPPORT
"_ SPREADER BRACKET
soc E HEAD SPREADEROAMP
SETSCREW _1_1------ - | _" /
7/8 IN. LONG_ _
"_lg _.1I I WING SCREW
/
FLAT WASHER j.,- I_) @-_ t/
17/64 IN. HOLE_,,,__
HEX NUT ---"_ LOCKWASHER
EXT. 1/4 IN.
2. MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position SPREADER SUPPORT on rod until it is even
with the end of the rod.
4. Assemble the 7/8 in. long setscrews, nuts, Iockwashers
and washers to the SPREADER SUPPORT BRACKET
and slip the nuts into the slot in the spreader support.
5. Finger tighten ONLY THE HEX NUTS.
SQUARE NUT
SPREADER"'+
SETSCREW I
FLAT i_)
WASHER @_
LOCKWASHER
HEX NUT _
I
I
I
Loading ...
Loading ...
Loading ...