Loading ...
Loading ...
Loading ...
page 5
5. Fan Assembly. (cont.)
wood ceiling
joist
hanging ball slot
hanging bracket tab
safety cable
wood screw
and washer
safety cable loop
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the hanging ball
slot until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) to secure safety cable loop.
If necessary, adjust the loop at the end of the safety
cable. The loop at the end of the safety cable should
just fit over the threads on the wood screw. Test safety
cable by pulling on loose end of cable with pliers. If the
safety cable slips, the loop must be adjusted smaller.
Extra cable slack can be left in ceiling area.
motor housing
6. Wiring.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, WIRE THE RECEIVER with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into
hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into
outlet box. Allow antenna from remote control
receiver to hang outside of hanging bracket.
["Wiring" continued on next page.]
ground (green
or bare)
white supply wire
black supply wire
black
black
white
blue
blue
white
from receiver
black
AC IN L
AC IN N
white
white
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
black
*
(wiring for receiver)
Loading ...
Loading ...
Loading ...