Loading ...
Loading ...
Loading ...
13. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch (if
applicable). Test wall control (optional installation) by locating
ON/OFF slider switch on wall control, then set to the ON
position. Test the light ON/OFF and dimmer function with L1
button and then test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by pressing the L1
button; test the dimmer function by pressing the L1 button
and holding it down for up to 5 seconds. Test fan speeds with
the different fan speed buttons. If the wall and/or handheld
remote control operates all of the functions of the fan and light,
battery/batteries has/have been installed correctly. If the wall
and/or handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse direction.
Use REV button to recirculate air depending on the season.
NOTE: If the wall control/handheld remote control interfere(s)
with other appliances, turn off power first and then go back to
the instructions in Section 11 above.
page 10
12. Remote Control Operation.
11
-
22
-
wall control
11
-
22
-
handheld
remote control
ON/OFF slider switch - turns wall control ON or OFF
(switch not functional on
handheld remote)
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before
reversing blade direction)
CAUTION: The wall and/or handheld remote control can be programmed to multiple
receivers or fans. If this is not desired, turn wall switch off to any other programmable
receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall
control to the ON position. Within 60 seconds of turning on the wall control,
press and hold the fan OFF button on the wall control for 5 seconds (or until
light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on. Within
60 seconds of restoring the power, press and hold the fan OFF button on the
handheld remote control for 5 seconds (or until light blinks twice or fan blades
begin to turn).
Test the light and fan functions to confirm the learning process is complete--see
Section 13 below.
11. Automated Learning Process./Activating Code.
Loading ...
Loading ...
Loading ...