Loading ...
Loading ...
Loading ...
page 9
11
-
22
-
DIM ON
10. Assembly of Handheld Remote Control. (cont.)
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
Since this fan comes with a dimmable LED
bulb, the dimmer switch (labeled DIM and ON)
has been pre-set to the "ON" position (DIM). If
you do not wish to have dimming capability,
please move the switch to the "OFF" position
(ON). [Refer to diagram 2.]
Attach black faceplate to front of wall control;
press down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT: Store the handheld remote
control away from excess heat or humidity. To
prevent damage to handheld remote control,
remove the battery if hnadheld remote control
will not be used for long periods.
CAUTION: “DO NOT DISPOSE OF BATTERIES IN
FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When
disposing of household alkaline batteries, it is
best to check with your local and state recycling
or household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
diagram 3
post
hole
remote control
cover, TOP
dimmer
switch
wall control
wire
wire
wire
12V battery
11
-
22
-
DIM ON
diagram 2
Loading ...
Loading ...
Loading ...