Loading ...
Loading ...
Loading ...
15
INSTALLATION
WHEN VENT PIPE EXTENDS TO CHIMNEY TOP
1.
You will need a pipe length equal to the chimney height (from hearth) plus 6 inches. If outside combustion air is to be used,
you will need a pipe length equal to the chimney height plus 12 inches.
2. Attach cerablanket wrap (not included) to the end of vent pipe that will connect to the stove. Use 12-inch lengths of light
gauge metal wire (not included) or metallic tape (not included). This is to protect interior components from excess heat.
3.
Set the insert on the hearth and slide it in far enough to attach the vent pipe (and combustion pipe if used).
4. Attach fl ashing (refer to Figure 13), route power cord out the side nearest a 120V receptacle. Slide in insert.
5. Measure and build chimney top. Cut out hole for vent pipe (and combustion air intake pipe, if used). Install and seal with
a non-hardening mastic to prevent water leakage. Install the vent cap.
6”
6”
MAX
15”
12”
HEARTH
NOTE:
FOLLOW METAL
CHIMNEY INSTALLATION
INSTRUCTIONS
TOP PLATE
(SEAL TO CHIMNEY TOP
WITH NON-HARDENING
MASTIC)
EXTENSION TO CHIMNEY TOP OPTIONAL.
(REQUIRED IN MOBILE HOME AND ZERO-
CLEARANCE FIREPLACES.
RECOMMENDED IN ALL FIREPLACES).
3 OR 4 INCH STAINLESS STEEL
SINGLE WALL PIPE.
BLANKING PLATE (SEAL WITH
NON-HARDENING MASTIC).
CHIMNEY NEED ONLY EXTEND
12” ABOVE BLANKING PLATE.
3 OR 4 INCH STAINLESS STEEL
FLEX PIPE.
FIREPLACE INSERT
SIDE ELEVATION
1” CERIBLANKET
NOTE:
WHEN MANTLE EXTENDS
MORE THAN 6” FROM
FIREPLACE FACE, A 15”
MINIMUM DIMENSION
MUST BE MAINTAINED
FROM STOVE TOP TO
BOTTOM OF MANTLE.
FIGURE 13
EXHAUST PIPE INSTALLATION
Loading ...
Loading ...
Loading ...