Loading ...
Loading ...
Loading ...
www.insigniaproducts.com
10
• For correct operation, you should level your refrigerator using the leveling feet. If you do not level your refrigerator, the
doors may not close or seal correctly, causing cooling, frost, and moisture problems. Turn the leveling feet clockwise to
raise or counterclockwise to lower a side. The leveling feet are easier to adjust if you have someone push against the
top of your refrigerator to take some weight off.
• When moving your refrigerator, do not tilt it beyond 45 ° from upright.
Finding a suitable location
• Place your refrigerator on a floor that is strong enough to support your refrigerator when it is fully loaded.
• Do not install your refrigerator on carpeting or a rug.
• Your refrigerator is designed to be free standing and should not be recessed or built-in.
• This refrigerator is designed for indoor, household use only. If you use your refrigerator in a garage, make sure that the
ambient temperature is between 55° F (13° C) and 110° F (43° C). If you operate your refrigerator outside this
temperature range, your refrigerator may not work correctly. The preferred room temperature range for optimum
performance, which reduces electricity usage and provides superior cooling, is between 60° F (15° C) and 90° F (32° C).
It is recommended that you do not install the refrigerator near a heat source, such as an oven or radiator.
• Before moving, retract the leveling legs to avoid scraping the floor, then adjust the feet to keep your refrigerator level.
• If you locate your refrigerator next to a fixed wall, allow sufficient space on the sides for the doors to swing open.
• The refrigerator has wheels, which should be used for only forward and backward movement. Moving the refrigerator
sideways may damage your floor.
• Position your refrigerator away from direct sunlight and sources of heat, such as a stove, heater, or radiator. Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent your refrigerator from performing correctly.
• Avoid locating your refrigerator in moist areas.
Locating near a water supply
A cold water supply with water pressure between 30 and 125 psi (207 and 862 kPa) is required to operate the ice maker. If
the refrigerator is installed in an area with low water pressure (below 30 psi (207 kPa)), you can install a booster pump to
compensate for the low pressure. Under normal conditions, a 200cc (5.75 oz.) cup can be filled in about 10 seconds. If the
water pressure is less than what is required, ice cubes could be hollow or irregularly shaped. If you have questions about
your water pressure, call a licensed, qualified plumber.
If you’re using a reverse osmosis water supply:
IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the
refrigerator needs to be between 30 and 125 psi (207 and 862 kPa).
If water pressure is too low:
Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.
Allow the storage tank on the reverse osmosis system to refill after heavy use. The tank capacity could be too small to keep
up with the requirements of the refrigerator.
If you have questions about your water pressure, call a licensed, qualified plumber.
WARNING: Excessive Weight Hazard
• Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury.
• Handle with care when moving refrigerator to avoid either damaging the refrigerant tubing or increasing the risk of a leak.
WARNING: Fire or Explosion Hazard
• Do not puncture refrigerant tubing.
• Follow handling instructions carefully.
• Flammable refrigerant used.
• Failure to do so can result in death, explosion, or fire.
CAUTION: Your refrigerator is heavy. When moving the refrigerator for cleaning or service, cover the floor with cardboard or hard
board to avoid floor damage. Always pull the refrigerator straight out when moving it. Do not wiggle or “walk” the refrigerator when
trying to move it, as floor damage could occur.
WARNING: Explosion and Fire Hazard
Keep flammable materials and vapors, such as gasoline, away from appliance. Failure to do so can result in death, explosion, or fire.
WARNING: Fire or Explosion Hazard
Do not puncture refrigerant tubing. Follow handling instructions carefully. Flammable refrigerant used. Failure to do so
can result in death, explosion, or fire.
CAUTIONS:
• A qualified plumber should make the water connection.
• Using water pressure that is outside the 30 to 125 psi (207 to 862 kPa) range can cause serious malfunction and severe, damaging
water leaks.
Loading ...
Loading ...
Loading ...