Patriot Lighting E8972BZ Dualux Bronze LED Dual Head Motion Sensor Outdoor Security Flood Light w/ Emergency Backup

User Manual - Page 4

For E8972BZ. Also, The document are for others Patriot Lighting models: E8972W

PDF File Manual, 8 pages, Read Online | Download pdf file

E8972BZ photo
Loading ...
Loading ...
Loading ...
Page 4 of 8
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
D
200810
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 4
Fig. 2
Fig. 3
Adjusting the Light Head (C):
Sensitivity of Motion Sensor
● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the middle of
the bottom surface of the sensor. (See Fig. 5)
● Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to achieve desired performance.
● Approximate range for each setting: 70 ft. (H), 45 ft. (M), 20 ft. (L).
Adjusting the Sensor Head (D):
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with controls facing
toward the ground.
Fig. 1
1. Adjust the light head up or down, left or right for desired area. Keep the light heads at least 1˝ (25mm) away from
the sensor.(See Fig. 4)
2. Keep the light heads (C) 30˚ below horizontal to avoid water damage and electrical shock.
2. You can rotate the sensor head up and down to change the coverage
area. (See Fig. 1)
Note: Range set too high may increase false triggering.
(See Fig. 2 and Fig. 3)
Choose a mode by sliding the switch on the bottom of the sensor. (See Fig.5)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
1. Test mode (daytime or nighttime operation )
● Set the time switch to the “TEST” position. (See Fig.5)
● With the power on, the light turns to low-level brightness automatically.
● The light turns to high-level brightness when motion is detected, and stays on as long as the motion continues.
Then it reverts back to low-level brightness about 5 seconds after motion is no longer detected.
Note: You can adjust the low-level (0~50%) and high-level (50~100%) brightness by using the brightness
switch on the backplate. (See Fig. 6)
C
C
C
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
FUNCTION AND OPERATION
Loading ...
Loading ...
Loading ...