Loading ...
Loading ...
Loading ...
Page 15
Fig. 5
5. Turn the motor on by f lipping the switch on
the power head to the ‘I’ ON position or f lip
the switch to the remote control position
and use the ‘I’ ON button on the remote
control.
DO NOT SUBMERGE THE REMOTE
CONTROL IN LIQUIDS.
6. After wet vacuuming, turn the machine off
and remove plug from power supply. Empty
the collection tank (fig. 6), clean and dry the
inside and outside of the collection tank,
and remove the foam wet filter and allow to
air dry before storage.
Fig. 6
IMPORTANT!
When vacuuming large
quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a f loat valve that stops the
suction action when the collection tank reaches
its maximum capacity. You will notice an
increase in motor speed. When this happens,
turn off the machine, disconnect from power
supply, and empty the liquid into a suitable
receptacle or drain. To continue vacuuming,
refit the power head to the collection tank.
After wet vacuuming, turn the machine off and
remove plug from power supply. To prevent the
risk of possible mildew, empty the collection
tank, clean and dry the inside and outside of
the collection tank, and remove the foam wet
filter and allow to air dry before storage.
REMEMBER!
The foam wet filter must be
removed after wet vacuuming, and a cartridge
filter must be installed before dry vacuuming
again.
LIQUID VACUUM OPERATION
Loading ...
Loading ...
Loading ...