Loading ...
Loading ...
Loading ...
Page 12
DRY VACUUMING
WARNING:
BE SURE TO READ,
UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS &
WARNINGS’. DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS
FROM VAPORS OR DUST, DO NOT
VACUUM TOXIC MATERIALS.
WARNING:
DO NOT PLUG IN
POWER CORD TO POWER OUTLET. MAKE
SURE PLUG IS DISCONNECTED BEFORE
CHANGING OR CLEANING FILTERS.
NOTICE!
Do not vacuum drywall dust or
fireplace soot or ash with standard Wet/Dry
filter. This is a very fine dust which will not be
captured by the filter and may cause damage
to motor. When vacuuming fine dust use a fine
dust filter.
1. Verify that the power cord is disconnected
from the outlet. (fig. 1)
Fig. 1
2. In order to prepare your vacuum for dry
vacuuming, verify that the cartridge filter
is securely mounted. With the power head
removed and in the upside down position,
make sure the filter is pushed in until it
stops against the power head. (fig. 2) Your
Wet/Dry Vac comes with the cartridge
filter pre-installed. For filter installation
instructions, see page 18.
Fig. 2
3. Place filter retainer on top of cartridge filter
and tighten down by turning the retainer
handle clockwise. (fig. 3)
Fig. 3
4. Place the power head back on the collection
tank, aligning the top section with the
latches, and lock into place. (fig. 4)
Fig. 4
DRY VACUUM OPERATION
Loading ...
Loading ...
Loading ...