Loading ...
Loading ...
Loading ...
23
NS-FWM27W1
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
4 Connect the ends of the water supply hoses to the water supply intake
connections at the back of your washer. The water supply hose connected to
the hot faucet must be connected to the hot water supply intake and the
water hose connected to the cold faucet must be connected to the cold water
supply intake.
5 Tighten the fittings by hand until they are snug, then tighten them an
additional two-thirds of a turn with pliers or a wrench.
6 Turn on the hot and cold water supplies, then check all the water supply
intake connections and the faucets for water leaks.
Note:
• If you don't want to use the hot water faucet or you don't have a hot water faucet,
you have to adjust the Temp. setting to cold, or your washer will have an Error code
E10.
• If you only have cold water faucet, we recommend that you buy and install a
T-branch pipe.
CAUTIONS:
• Don’t overtighten the fittings or apply tape or sealant to the faucets or water
supply intakes. This can damage the fittings.
• Make sure that the water supply hoses aren’t twisted or bent. A bent or twisted
hose can leak and cause an electric shock because of water leakage.
Back of washer
Cold water supply
Hot water supply
Water supply hoses
Loading ...
Loading ...
Loading ...