Loading ...
Loading ...
Loading ...
10.0 optional remote installation
A. Remove the battery pack from the receiver. Then by pulling down, remove the receiver cover and slide
the receiver into the hole located at the rear of the burner base. Secure using the two screws provided.
B. Secure the faceplate to the receiver with two of the screws provided.
C. Insert the battery pack (with batteries installed) through the opening in the faceplate and into the
receiver. The battery pack is secured and released with a catch mechanism. Push the receiver into the
catch to secure.
D. Insert the slide switch into its marked position on the faceplate.
E. Replace the existing switch wires connected to the terminals on the valve marked TH/TP and TH with
those running from the receiver.
RECEIVER
BATTERY
PACK
SLIDE
SWITCH
FACEPLATE
PRESS
TO OPEN
FIREPLACE REMOTE
OFF
ON
R
EMOTE
BA
T.LOW
VALVE
REAR BURNER BASE
The remote switch on the side of the appliance is no longer operational.
note:
• The transmitter and receiver are not waterproof. Ensure both components are not exposed to water.
!
WARNING
EN
W415-1796 / B / 08.01.18
25
Loading ...
Loading ...
Loading ...