Loading ...
Loading ...
Loading ...
6.0 gas installation
!
WARNING
• Risk of fire, explosion, or asphyxiation. Ensure there are no ignition sources such as sparks or open flames.
• Support gas control when attaching gas supply pipe to prevent damaging gas line.
• Purging of the gas supply line should be performed by a qualified service technician. Ensure that a continuous
gas flow is at the burner before closing the door. Ensure adequate ventilation. For gas and electrical locations,
see “appliance dimensions” section.
• All gas connections must be contained within the appliance when complete.
• High pressure will damage valve. Disconnect gas supply piping before testing gas line at test pressures above
1/2 PSIG.
• Valve settings have been factory set, do not change.
Installation and servicing to be done by a qualified installer.
• Move the appliance into position and secure.
• If equipped with a flex connector, the appliance is designed to accept a 1/2” (13mm) gas supply. Without the
connector, it is designed to accept a 3/8” (9.5mm) gas supply. The appliance is equipped with a manual shut
off valve to turn off the gas supply to the appliance.
• Connect the gas supply in accordance to local codes. In the absence of local codes, install to the current
CAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 / NFPA
54 in the United States.
• When flexing any gas line, support the gas valve so that the lines are not bent or kinked.
• The gas line flex-connector should be installed to provide sufficient movement for shifting the burner assembly
on its side to aid with servicing components.
• Check for gas leaks by brushing on a soap and water solution. Do not use open flame.
EN
W415-1796 / B / 08.01.18
17
Loading ...
Loading ...
Loading ...