Loading ...
Loading ...
Loading ...
8
WARRANTY
One-Year Limited Warranty on Mechanical Parts.
For one year from the date of purchase, supplier will repair or
replace any of its mechanical parts if defective in material or
workmanship. This Pedestal must be installed with the listed
washer or dryer and operated according to the instructions
provided in the washer or dryer Owner’s Manual or Use and
Care Guide.
Warranty Restriction
If the Pedestal is subject to other than private family use and/or
used with any other product than those listed in the Installation
Instructions, the warranty is null and void.
Warranty Service
Warranty service is available by contacting the retailer where
the Pedestal was purchased. If retailer is not available, please
refer to the Owner’s Manual or Use and Care Guide that came
with the washer or dryer that is installed with the Pedestal and
contact the service department listed there.
This warranty applies only while the Pedestal is in use in the
United States or Canada*. This warranty gives you specic legal
rights and you may also have other rights which vary from state
to state or province to province.
*Warranty terms may vary in Canada.
In the space below, record your model number information and
purchase date. See the serial plate located behind the drawer on
the side frame of the Pedestal, for model number information.
Have this information available to help you quickly obtain
assistance or service.
Model number ___________________________________________
Serial number ____________________________________________
Item number _____________________________________________
Purchase date ___________________________________________
Save these instructions and your sales receipt for future
reference.
10. Securely tighten jam nuts
When the washer/dryer is level, use a 9/16" open-end wrench
to securely tighten all four jam nuts against the pedestal.
IMPORTANT: The jam nuts must be tightened to avoid
vibration.
12. Place drawer divider
Hex-head screw
Drawer slide
11. Reassemble pedestal drawer
Pull both drawer slides out and reassemble the drawer to the
drawer slides with the two hex-head screws.
Remove the divider from the bag. Place the divider in the
drawer at the desired location. Close the drawer.
NOTE: Use of the divider is optional.
Loading ...
Loading ...
Loading ...