Loading ...
Loading ...
Loading ...
5
Uninstalling your electric dryer
1. Unplug the power supply cord or disconnect wiring if dryer is
direct wired.
2. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
3. Pull the dryer away from the wall so that it can be tipped on
its back.
4. To avoid oor damage and for ease of installation and
handling, unfold the empty pedestal box at and place it
next to the dryer. Lay the dryer on its back (make sure that
the power supply cord is not under the dryer) so that the
cardboard is under the entire lower back edge of the dryer.
Go to “Installing the Pedestal”.
Uninstalling your gas dryer
1. Unplug the power supply cord.
2. Turn off the gas supply.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Disconnect the exible gas supply line from the dryer. Put a
piece of tape over the open ends of the gas line connection
ttings.
5. Pull the dryer away from the wall so that it can be tipped on
its back.
6. To avoid oor damage and for ease of installation and
handling, unfold the empty pedestal box at and place it next
to the dryer. Lay the dryer on its back (make sure that the
power supply cord is not under the dryer) so that the
cardboard is under the entire lower back edge of the dryer.
Go to “Installing the Pedestal”.
2. Washer transport bolts
Installation of new washer/dryer
If your washer/dryer is still in the packaging:
Washer: Cut plastic lm along dotted cut line around the base.
Do not remove the packaging.
Dryer: Cut carton around top and down corners along dotted
cut lines. Lay all four carton sides on oor. Discard carton top
and corner posts. Lay the dryer on its back.
1. Unpacking Washer/Dryer
Washer
Dryer
Locate the transport bolts on rear of washer. Transport bolts
must remain in washer before pedestal can be installed. Lay the
washer on its back. When laying the washer on its back, hold the
bottom cap down on the oor. Do not remove the plastic lm,
corner posts, or top cap.
Base
Loading ...
Loading ...
Loading ...