Loading ...
Loading ...
Loading ...
Control Panel
It’s a good idea to wipe the control panel after
each use of the oven. Clean with mild soap and
water or vinegar and water, rinse with clean
water and polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven cleaners
RQWKHFRQWUROSDQHO³WKH\ZLOOGDPDJHWKH
finish. A 50/50 solution of vinegar and hot
water works well.
GEAppliances.com
Lift-Off Oven Door
The oven door is removable, but it is heavy. You
may need help removing and replacing the
door. Do not lift the door by the handle. This can
cause the glass to break or can cause damage
to the door.
To remove the door, open it a few inches to
the special stop position that will hold the door
open. Grasp firmly on each side and lift the
door straight up and off the hinges.
NOTES:
Be careful not to place hands between the
hinge and the oven door frame as the hinge
could snap back and pinch fingers.
While working in the oven area, cover the
hinges with towels or empty paper towel rolls
to prevent pinched fingers and chipping the
porcelain enamel on the frame.
To replace the door, make sure the hinges
are in the special stop position. Position the
slots in the bottom of the door squarely over
the hinges. Then lower the door slowly and
evenly over both hinges at the same time. If the
hinges snap back against the oven frame, pull
them back out.
To clean the inside of the door:
Do not allow excess water to run into any
holes or slots in the door .
Because the area inside the gasket is
cleaned during the self clean cycle, you do
not need to clean this by hand. Any soap left
on the liner causes additional stains when
the oven is heated.
The area outside the gasket can be cleaned
with a soap-filled plastic scouring pad.
To clean the outside of the door:
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to
clean the glass on the outside of the door.
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing
acids may cause discoloration and should be
wiped up immediately. When the surface is
cool, clean and rinse.
Do not use oven cleaners, cleansing powders
or harsh abrasives on the outside of the door.
Lift the door straight up and off the
hinges.
The gasket is designed with a gap
at the bottom to allow for proper
air circulation.
Do not rub or clean the door
JDVNHW³LWKDVDQH[WUHPHO\ORZ
resistance to abrasion.
If you notice the gasket becoming
worn, frayed or damaged in any
way or if it has become displaced
on the door, you should have it
replaced.
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free number:
National Parts Center 1.800.626.2002
GEAppliances.com
Stainless Steel Surfaces
21
Loading ...
Loading ...
Loading ...