Loading ...
Loading ...
Loading ...
12
DISASSEMBLY
Tools Required
You will need a #2 Phillips screwdriver.
Workspace Recommendations
A counter top or flat surface is ideal for disassembling/assembling your purifier. You
will need 2ft x 3ft of clean, accessible workspace. It is recommended to use a small
bowl or cup to hold any screws so they are not lost during the /assembly process.
Disassembly Instructions
1. Turn the purifier off.
2. Remove the POWER CORD PLUG from the wall and the DC POWER ADAPTER
PLUG from the rear of the purifier.
3. Clean exterior of purifier if necessary (see “CLEANING” page 16).
Removing the REAR COVER:
1. Using your screw driver, remove the REAR COVER SCREW from the REAR COVER
(above the DC POWER ADAPTER INLET). Place the REAR COVER SCREW where
you will find it easily during reassembly.
2. Squeeze the sides of the REAR COVER until they release and tilt the REAR COVER
slightly upwards and pull directly away from the unit. Clean with compressed air
or a damp cloth. Set the REAR COVER aside.
Removing the FILTER ASSEMBLY:
1. Remove BRASS THUMBSCREWS from the top corners of the FILTER ASSEMBLY.
2. Place BRASS THUMBSCREWS where you will find them easily during reassembly.
3. Grasp the top of the FILTER ASSEMBLY and tilt away from the purifier. Clean if
necessary (see “CLEANING” page 16) and set the FILTER ASSEMBLY aside. Lift
FILTER ASSEMBLY TABS on either side of FILTER ASSEMBLY to remove the rim and
access the separate honeycomb, foam and mesh layers.
Loading ...
Loading ...
Loading ...