Loading ...
Loading ...
Loading ...
11
CONTROLS
Turning the Purifier On/Off
Press the POWER BUTTON on the CONTROL PANEL or REMOTE to turn the purifier on.
The purifier will initially be set to NORMAL MODE (PCO). Press the POWER BUTTON once
more to turn the power off.
Using NORMAL MODE (PCO)
Press NORMAL/HIGH MODE TOGGLE until “PCO” is shown in the MODE SPECIFIC DISPLAY.
• Square Footage not available in “NORMAL MODE (PCO)”
• To control the fan speed: Use Fan Up/Down buttons.
Using HIGH MODE
Press the NORMAL/HIGH MODE TOGGLE and verify that “HIGH MODE” is shown in the
MODE INDICATOR.
• To set the square footage on the DISPLAY:
Use PURIFIER LEVEL CONTROL (See “INITIAL SETTINGS” page 10).
• To control the fan speed: Use FAN SPEED CONTROL.
Never adjust setting to exceed square footage of ventilated space being treated.
Using AWAY MODE
Press the AWAY MODE TOGGLE and verify that “AWAY MODE” is shown in the MODE
INDICATOR.
• To set the AWAY MODE TIMER: press the AWAY MODE TOGGLE. Each press of the
AWAY MODE TOGGLE adds two hours to the AWAY MODE TIMER.
• Select 2:00, 4:00, 6:00 or 8:00 hours.
• Press AWAY MODE once when the AWAY MODE TIMER shows 8:00 will revert the
purifier back to the mode it was in before you pressed the AWAY MODE TOGGLE.
Using SLEEP MODE
If the light produced by the DISPLAY and CONTROL PANEL causes a distraction, such
as when sleeping or viewing your television, simply press the SLEEP MODE CONTROL on
the REMOTE and the lighting will cycle through: low brightness, off, high brightness.
Loading ...
Loading ...
Loading ...