Loading ...
Loading ...
Loading ...
12 TurboLock TL - 200
Step 3. Plug the cable into the inside section via the white connectors. Make sure
the lines and notches from each connector are on the same side.
Step 4. Check that the lock is set for the correct orientation. If needed, adjust the
switch and thumb turn according to the orientation needed for your door.
Step 5. Fit the inside section over the plate; make sure to thread the latch pin into
silver center part and tuck the cords away from the lowest screw hole. (Fig. 6)
Step 6. With the inside section at against the back of the door, use the 4x inside screws to fasten it to the back of the door.
Check the images and note the placements for the dierent sized screws. (Fig 7.) Make sure all screws are tightened.
Check and adjust the cables as needed to make sure they are tucked away from any screw hole opening. Do NOT
force the screw through the cables as this will damage the lock and/or make it unusable.
(Fig. 6) (Fig. 7)
Silver Center Part
Latch Pin
Loading ...
Loading ...
Loading ...