Loading ...
Loading ...
Loading ...
12
13
5 secs
Night mode
If the machine is not in auto mode, the airflow speed will reduce to level 4. When night mode is activated, if it is already
below level 4, it will remain the same. This can be manually changed if desired. The display will illuminate briefly, then fade
as before. If in auto mode the airflow speed will be reduced automatically.
When night mode is enabled (indicated by an illuminated
crescent moon symbol in the bottom right corner of the
display), the display will dim and after 5 seconds will fade
to off. The crescent moon symbol remains illuminated.
The night mode will dim the display and run quietly, making it ideal for use while sleeping.
Diffused and focused modes
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to a whole
room airflow.
Heating and cooling modes
work in this mode.
Focused mode
Press the narrow angle
button to change from a
whole room airflow to a
personal directed airflow.
Heating and cooling modes
work in this mode.
Oscillation
Airflow speed control
Airflow speed control
To change the airflow speed
press the airflow control
button. The digital display
will show the new fan speed.
If in heater mode after
2.5 seconds it will change
back to displaying the target
temperature.
Oscillation control
To start the machine
oscillating, press the
oscillation control button.
To stop the machine
oscillating, press it again.
The machine will not
oscillate when the control
buttons are pressed.
This machine is hot when in use and for a
short period after use. Do not let bare skin
touch hot surfaces. If children are present,
consider positioning the machine out of
their reach.
Unplug from the main power source. If the machine has been in use, leave for
1 to 2 hours before cleaning to allow the machine to cool completely. Dust may
accumulate on the surface of the machine. Wipe dust from the loop, filter unit and
other parts with a dry or damp cloth when dust accumulates. Do not use detergents
or polishes.
Clearing blockages
Caution: hot when in use
Cleaning
Unplug from the main power source. If the machine has been in use, leave for 1 to 2 hours in order to allow the machine to cool
down completely. Look for blockages in the air inlet holes and in the small aperture inside the air loop amplifier. Use a soft brush
to remove debris.
To set the sleep timer, select the desired time. When time
reaches zero, the machine will go into standby mode.
To cancel, increase the time until two dashes appear.
Sleep timer
Tilt function
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
The sleep timer will
turn your machine
off once the time set
has passed.
Loading ...
Loading ...
Loading ...