Loading ...
Loading ...
Loading ...
10
Please note :
• When using the appliance for the rst time, you need to
make 4-5 cups of coee or 4-5 cappuccinos before the ap-
pliance starts to give satisfactory results.
5. TURNING THE APPLIANCE ON
Please note :
Before turning the appliance on, make sure the main switch
(A2-g. 3)on the back of the appliance is in the I position.
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A18) and is collected in the drip tray underneath (A15). Avoid
contact with splashes of water.
• To turn the appliance on, press the button (B1-g.
4). The (B2) and (B4) lights ash while the
appliance is heating up and performing an automatic rinse
cycle. By circulating the hot water, the appliance heats the
boiler and the internal circuits. During this phase, the light
ashes.
When the
and lights remain on steadily, the
appliance is at temperature.
6. TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the button (B1-g. 4). The
appliance performs a rinse cycle then goes o.
Please note :
If the appliance is not used for an extended period, place the
main switch in the 0 position (A2-g. 6).
Important!
To avoid damaging the appliance, never place the main switch
(g. 6) in the 0 position while the appliance is on.
7. SETTING AUTOOFF STANDBY
The appliance is set by default to go o if not used for one hours.
The time can be changed so that the appliance switches o after
15 or 30 minutes, or after 1, 2 or 3 hours.
1. With the appliance o but the main switch in the l posi-
tion (A2-g. 3), press and hold the ECO button (B16) until
the lights at the bottom of the control panel come on (see
image after point 2).
2. Select the required period of time (15 or 30 minutes or 1,
2 or 3 hours) by pressing the (B7) button (see the
light/time table below).
15min 30min 1h 2h 3h
.
3. Press the ECO button to conrm the selection. Auto-o is
programmed.
Please note:
To disconnect the appliance completely, place the main switch
at the back of the appliance in the 0 position (g. 6).
8. SETTING TEMPERATURE
If you want to modify the temperature of the water used to
make the coee (low, medium, high, maximum), proceed as
follows:
1. With the appliance o (standby), but the main switch on
pos. I (A2-g. 3), press and hold the
button (B3-g.
11) until the lights on the control panel come on;
2. Press the button (B5-g. 12) to select the requi-
red temperature:
LOW HIGH
3. Press the button to conrm; the lights go o.
9. ENERGY SAVING
Use this function to activate or deactivate energy saving mode.
This reduces energy consumption in compliance with current
European regulations.
To activate the function, press the ECO button (B16), the light
(B17) comes on. To deactivate the function, press the ECO but-
ton. The light goes o.
Please note:
A few seconds may elapse between energy saving mode and
delivery of the rst coee as the appliance must heat up again.
Loading ...
Loading ...
Loading ...