Loading ...
Loading ...
Loading ...
166
MAINTENANCE
* Fog The Engine - 2 Strokes - Polaris Fogging Oil (PN 2870791)
follow directions on the can. 4-Strokes
- Remov e the spark plug and
add 2-3 tablespoons of Premi um 4 Syntheti c 0W40 engine oil. To
acces s the plug hol e use a section of clear 1/4″ hose and a sm al l
plasti c squeeze bottle filled with the pre-measured amount of oil.
Note: Do this carefully! If you miss the plug hole, oil will drain from
the spark plug cavity out the hole at the front of the cyl inder head,
and appear to be an oil leak. Instal lthe spark plug and pull the engine
over slowly with the recoil starter. Oil will be forced in and around the
pist on r i ngs and ring lands , c oati ng the c yli nder wi t h a protecti ve fi l m
of fresh oil.
Check and Lubricate Cables / Grease - Inspect all cables and
lubricate with Polaris Cable Lubricant. Follow lubrication guide-
lines in the Maintenance Section of the Service or Owner’s Manual
to completely grease and lubricate the entire vehicle with Polaris
Premium All Season Grease. Apply Polaris O-ring Chain Lube to
the drive chain(s).
Battery Maintenance - Remove the battery and add distilled wa-
ter as required to the properlevel. Do not use tap water which may
contain minerals that reduce battery life. Apply Polaris Di-Electric
Grease to the terminal bolts and terminals. Charge the battery at
1.4 amps or less until specific gravity of each cell is 1.265 or great-
er. Store the battery in a cool, dry, place. Charge can be main-
tained easily by using Polaris Battery Tendert charger (PN
2871076) or by charging about once a month to make up for nor-
mal self-discharge. Battery Tendert can be left connected during
the storage period, and will automatically charge the battery if the
voltage drops below a pre-determined point. The only thing you
need to do is check the fluid level once a month.
Engine Anti-Freeze - Test engine coolant strength and change if
necessary. Coolant should be replaced every 2 years.
Storage Area/Covers - Set tire pressure and safely support the
ATV with the tires 1-2″ off the ground. Be sure the storage area is
well ventilated. Cover the machi ne wit h a genuine Polar i s ATV cover.
NOTE: Do not use pl ast i c or coated m ater i al s . They do not allow
enough ventil ati on to prevent condensati on, and may promote corr o-
sion and oxidation.
Loading ...
Loading ...
Loading ...