Loading ...
Loading ...
Loading ...
−
−
−
The ignition switch must be in
ACCESSORY (I) or ON (II) to
operate the audio system. Turn the
system on by pressing the PWR/
VOL knob, the AM/FM button, or
the AUDIO DISPLAY button. Adjust
the volume by turning the PWR/
VOL knob.
The band and frequency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
seen in the upper display if the
stationisbroadcastinginstereo.
Stereo reproduction on AM is not
available.
You can use any of five methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN, AUTO
SELECT, and the preset icons.
The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, push and release the
SCAN button on the driver’s side of
the audio display or touch the SCAN
icon at the bottom of the display.
You will see SCAN in the display.
The system will scan up the band for
a station with a strong signal. When
it finds one, it will stop and play that
station for approximately five
seconds. If you do nothing, the
system will then scan for the next
strong station and play that for five
seconds. When it plays a station that
you want to continue listening to,
press the SCAN button or touch the
SCAN icon again.
Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob to the right to tune to
a higher frequency, or to the left to
tune to a lower frequency.
The SEEK function
searches the band for a station with
a strong signal. To activate it, press
the SEEK bar ( or ) until
you hear a beep, then release it.
Depending on which side of the
SEEK bar you press, the system
scans upward or downward from the
current frequency. It stops when it
finds a station with a strong signal.
Operating the Radio SCAN
TUNE
SEEK
Audio System
Comfort and Convenience Features
188
Main Menu
Table of Content
Loading ...
Loading ...
Loading ...