Loading ...
Loading ...
Loading ...
en Appliance door
24
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
1. The rail must sit between the two bars (fig. !).
2. Push the retainer at the back in between the lower
and the upper bar (fig. ").
3. Push on the "PUSH" tab and swing the rail in so that
the retainer ends up between the two bars (fig. #).
4. Release the "PUSH" tab; the retainer will hook into
place (fig. $). Then pull the rail out as far as it will go
and slide it back in.
qAppliance door
Ap p l i a n c e door
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Main oven – Fitting and removing the glass
panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
Locking the appliance door
1. Open the appliance door fully.
2. Open the two locking levers on the left and right
(fig. !).
3. Close the appliance door as far as it goes (fig. ").
Removing panels
1. Press the left- and right-hand sides of the cover
(fig. !).
2. Remove the cover (fig. ").
3. Lift out each panel (fig. #) and set them down
carefully on a flat surface.
4. If necessary, you can remove the condensate trough
for cleaning. To do this, open the appliance door
fully (fig. $).
1
2
2
1
2
1
Loading ...
Loading ...
Loading ...