Loading ...
Loading ...
Loading ...
Installation
52
Hot water
– The washing machine is programmed
for hot water operation at delivery.
– The temperature of hot water at the
faucet must not exceed 140°F (60°C).
The preferred temperature is 131°F
(55°C). Consult a plumber if the
temperature at the faucet exceeds
140°F (60°C).
– Before connecting to the water
faucet, check that the outflow of cold
water does not exceed 5 liters / 5
quarts. Each additional quart of cold
water reduces the energy efficiency.
– If the hot water supply is turned off
for some time, the washing machine
will automatically switch to the cold
water connection. This safety
measure is not intended for the
permanent operation of the
appliance. The washing machine
continues to wash using hot water
operation, but washing results are
worsened.
Reprogramming to cold water
operation
Press the Sensitive button until the
following appears in the display:
Water intake
OK
Hot + cold
Press the left menu button until
Cold appears in the display and
confirm this with the right menu
button OK.
Drainage
The 5 ft (1.5 m) drain hose may be
connected as follows:
1. Directly into a sink: hook the hose
over the edge of the sink and secure
it firmly (e.g. by tying the hose to the
water faucet).
2. To a stand pipe: place the drain hose
into a 1 ½" (4 cm) stand pipe and
secure it firmly.
3. To a floor drain: The machine is
equipped with an air gap / anti-
siphoning system so that no
minimum drain height is required.
– The machine drains using a pump
with a maximum delivery height of
4 ft (1.2 m).
– Make sure there are no kinks in the
drain hose.
– If necessary, the drain hose may
be extended to run a maximum of
16 ft (4.9 m), as long as the 4 ft
(1.2 m) height is not exceeded.
Hose extensions are available from
Miele as an optional accessory.
Loading ...
Loading ...
Loading ...