Loading ...
Loading ...
Loading ...
14
Installing
Follow steps 2 to 4 with doors that have two glass panels.
When installing, ensure that the "right above" inscription on the
lower left part is inverted.
1. Insert the glass panel by tilting it backwards (Figure A).
2. Insert the upper glass panel on both mounts by tilting it
backwards. Ensure that its smooth surface is facing
outwards. (Figure B)
3. Fit and tighten the cover.
4. Refit the oven door.
Once the glass panels have been correctly fitted, the oven is
ready to use.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Error messages
When the display panel shows an error message with
“, press
the
0 button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
: Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
Changing the oven bulb
If the oven light bulb is damaged it must be replaced. Special
25 W, E14, 220 V-240 V heat-resistant light bulbs (to 300 ºC
temperature) can be obtained from the Technical Support
Service or in specialist shops. Only use this type of bulb.
: Risk of electrical discharge and the resulting shock.!
Disconnect the appliance from the mains. Ensure that this is
turned off.
1. Place a dishcloth into the cold oven to avoid damage.
2. Remove the glass protection by unscrewing it to the left.
3. Replace the bulb with a similar bulb.
4. Screw the protection glass back into place.
5. Remove the dishcloth and switch the oven back on at the
mains.
Protective glass panels
Damaged protective glass panels must be replaced. Protective
glass panels cay be obtained from the Technical Assistance
Service. Please quote your appliance's product number and
production number.
%
$
Fault Possible cause Solution/advice
The oven does
not work.
The fuse has
blown.
Check the state of the fuse
in the fuse box.
Power cut. Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
The display
panel shows a
flashing
0 sym-
bol and four
zeros.
Power cut. Set the time once again.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs sev-
eral times in both direc-
tions.
Error message Possible cause Solution/advice
“‹‚‚
A button has
been pressed
for too long or
has got stuck.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Loading ...
Loading ...
Loading ...