Loading ...
Loading ...
Loading ...
42
FAILURE INDICATORS AND MESSAGES
Below is a summary of possible failure causes and
solutions.
If the problem persists after having removed the
cause of the failure, press and hold On/O for at least
three seconds. If afterwards the failure indication still
persists, close the water tap, switch o and unplug the
washing machine and contact our After-Sales Service.
Failure Indicator Possible Cause Solution
WATER TAP CLOSED
No or not sucient water supply
• Water tap closed
• Kinks in inlet hose
• Water tap pressure too low
• Mesh lters in inlet hose
clogged
• Water inlet hose frozen up
Open water tap
Make sure there are no kinks in the
inlet hose.
Make sure water pressure is
sucient.
Clean mesh lters in inlet hose
(CLEANING AND MAINTENANCE)
Install washing machine at an
ambient temperature of at least
5°C.
After problem has been removed,
press Start/Pause. If problem
persists, press and hold On/O for
at least 3 seconds.
CLEAN FILTER
Waste water is not pumped out
• Kinks in drain hose
• Drain hose blocked or frozen
up
• Filter blocked
• Pump blocked
Check drain hose for kinks
Install washing machine at an
ambient temperature of at least
5°C.
Clean water lter as described in
section CLEANING THE FILTER.
After problem has been removed,
press Start/Pause. If problem
persists, press On/O for at least 3
seconds.
Indication on display Possible Cause Possible Solution
DOOR OPEN
INDICATOR BLINKS
The door cannot lock Firmly press the door in area of
door lock, to properly close it.
Then press Start/Pause. If the
problem persists, press On/O
for at least 3 seconds.
Loading ...
Loading ...
Loading ...